Outdoor Rink Build
A flat, heat-tolerant skating surface built on a properly drained base, ready for year-round outdoor play.
What Goes Wrong
The surface system is only as good as the base underneath it. These are the failure modes that cut a court’s lifespan short.
A base without a designed drainage slope holds standing water after monsoon rain, which accelerates coating breakdown and panel joint failure.
Drainage slope is calculated during the site assessment and built into the base grade before any surface system is installed.
Spot-patching a cracked or uneven slab hides the damage without fixing it, the surface stays rough and the patch fails within a season.
The existing slab is evaluated for flatness, cracking, and structural soundness before any surface work is specified or priced.
Surface coatings not rated for high UV exposure break down quickly under Arizona’s outdoor temperatures, leaving a rough, unsafe skating surface.
Coating systems are selected specifically for UV tolerance and applied in layers matched to the base material and expected outdoor temperature range.
Arizona’s hardpan and caliche soil layers resist compaction and drainage, a base built over them without proper prep shifts and cracks over time.
Caliche depth and soil type are identified on-site so excavation depth and sub-base compaction are scoped correctly before the estimate is written.
Surface Options
From a new backyard rink to a full facility rebuild, the scope covers every layer from base to boundary line.
Interlocking sports tile panels install over concrete or asphalt, require no adhesive, and allow section-by-section replacement if a panel degrades.
A concrete slab base finished with a UV-rated surface coating delivers a harder, faster skating surface with a flatness tolerance under 3/16 inch.
Asphalt base work provides a stable, compacted foundation for tile or coating systems on sites without an existing concrete slab.
Goal areas, face-off spots, and rink boundary lines are laid out to regulation dimensions and applied after the surface system is complete.
Ground is graded to the correct drainage slope before base work begins.
Slope and runoff path designed to prevent standing water.
Full-court slip check completed before handover.
Edge containment and perimeter defined to the court layout.
Why Choose Us
Every build is arranged through a local court builder who knows Arizona site conditions, not a general contractor guessing at skating surfaces.
Soil type, drainage, and space are checked in person before any number is put in writing.
Base prep, surfacing, drainage, and line marking are each priced as separate line items, no lump sums.
Court builds are arranged across Arizona, from single backyard rinks to HOA and commercial facilities.
Surface flatness, drainage slope, and boundary markings are all confirmed before the job is considered complete.
The service covers new builds, worn-court resurfacing, and repair across backyard, club, and HOA settings.
How It Works
01
Submit the site location and intended use, and a local court builder is arranged to visit and evaluate the ground in person.
02
An itemised estimate covering base preparation, surface system, drainage, and line marking is delivered after the on-site evaluation.
03
The court is built to the agreed scope, then a final walkthrough confirms flatness, drainage, and surface condition before sign-off.
Pricing Estimates
| Job | Typical cost |
|---|---|
| Roller hockey practice pad | $20,000-$40,000 |
| Backyard roller hockey court | $30,000-$75,000 |
| Full hockey or roller hockey court | $50,000-$120,000 |
Tell us the site and the sport. We’ll arrange a local court builder to evaluate the ground and deliver an itemised written estimate.